59
Appendix B—Remote Control Operation
Initial Pairing
Before the remote control can be used with the
fi
replace, it must be paired. See “Remote Control Initial Pairing” on
page 49.
Remote Control Operation
NOTE: Before using the remote control system for the first time,
the receiver and the handset must be paired. See
the section
Remote Control Initial Pairing
on the
ȴ
rst page of this manual.
Main Display
To Turn O
Fire
Press to turn OFF.
Note:
There is a 2 minute delay after
switching o
before the next ignition is
possible.
Flame Height Adjustment
To increase
ȵ
ame height, press and
hold .
To decrease
ȵ
ame height, press and
hold . You may hold the button
down until the
ȴ
re is set to pilot
ȵ
ame
only.
CAUTION:
Always check the
ȴ
re and pilot visu-
ally to ensure they are o
.
AM
ON
OFF
PM
AM
Thermostatic Mode
Signal Indicator
Child Proof
Light
Fan (if included)
Program Mode
Temperature
Time
Auxiliary Feature (not used)
Countdown Timer
Battery Status
Eco Mode
°F or °C
To Turn On Fire
One-Button lighting (default):
Two-Button lighting: +
simultaneously
Press and hold for 4 seconds, until 8
short beeps and a blinking series of
lines con
ȴ
rms the start sequence has
begun. Release button.
Main gas
ȵ
ows once pilot ignition is
con
ȴ
rmed.
Handset automatically goes into
manual mode after main burner
ignition.
Standby Mode (Pilot Flame)
Press and hold to set appliance to
pilot
ȵ
ame.
NOTE:
When pilot ignition is con
ȴ
rmed, motor
automatically turns to maximum
ȵ
ame height.
CAUTION:
If the pilot does not stay lit after
several tries call your local service technician or
gas supplier.
(not available)
(not available)
