Operation
Valley ClassicPlus Control Panel
26
Starting The System Dry (Without Water)
1. Inspect the wheel tracks to ensure there are no
vehicles or other equipment which will obstruct
the system upon start-up or operation.
2. Place the WET/DRY switch in the DRY position
to by-pass the low pressure switch.
3. If an engine shutdown circuit is utilized, place the
Engine RUN/START switch in the START position.
4. Turn the main disconnect switch to the ON posi-
tion. If the power is supplied by an engine driven
generator, adjust the RPM of the generator until
the voltmeter reads 480 – 505 volts. DO NOT EX-
CEED 505 VOLTS.
5. Select the direction of travel by placing the
FORWARD/REVERSE switch in either the
FORWARD or REVERSE position. Remember,
Forward is clockwise and Reverse is counter-
clockwise.
6. Press the START-STOP switch to the START lo-
cation for 1 – 2 seconds and release. The system
should now start.
7. Place the Engine RUN/START switch in the RUN
position.
8. Set the percentage timer to the desired speed
setting.
9. If the system is equipped with the optional stop-
in-slot, place the SIS ON/OFF switch in the de-
sired position.
10. If the system is equipped with the optional drive
unit mounted auto reverse/auto stop hardware,
place the Auto Reverse/Auto Stop switch in the
desired position.
ClassicPlus
AUTO
REVERSE
AUTO
STOP
LINEAR
PIVOT
STARTING THE SYSTEM DRY
1
2
7
3
4
5
6
8
9
10
Figure 26-1
1. Set to DRY
2. Set to START
3. Turn Main Disconnect to ON
4. Voltmeter Reading between 480-505 Volts
5. Select Forward or Reverse Direction
6. Press START for 1-2 Seconds to Start Machine
7. Set to RUN
8. Select Desired Percentage Timer Setting
9. Set SIS to ON/OFF
10. Select Auto Reverse or Auto Stop (if installed)
