Single & Dual Zone Heat Trace Control Panel | Valin Corporation
Alarm Annunciation
In order to clear alarm messages, you must be logged into the system and the alarm condition must be cleared.
If alarms are set to
“NON-LATCHING”,
as described in
Figure 4-8
on page 32, the alarm will automatically clear
when the trigger condition is resolved.
TROUBLESHOOTING
When an alarm is triggered the
Home Screen
will display an alarm message, shown in
Figure 6-1
above. Clear
this by pressing the
“ACTIVE ALARM”
button in the bottom left of the screen. This will display the
Active
Alarms Screen
below:
The activated alarm will be highlighted in red as shown in
Figure 6-2
. Press the
“ALARM RESET”
button.
The process condition must be within set parameters or acceptable range before the active status will be
cleared.
FIGURE 6-1
ALARM SCREEN
NAVIGATION
FIGURE 6-2
ALARM SCREEN
61