Page 56
Installation Instructions and Owner’s Manual - L48
ENGLISH
LOGS AND ROCKS KIT INSTALLATION
Tools Needed
• Protective Gloves
• Phillips Screw Driver or Power Drill with
Phillips Drive
Before You Begin
It is recommended that prior to installing the
logs and rock kit, test fire the fireplace to make
sure it is operational.
Do not, handle the logs with bare hands!
Always wear gloves to prevent skin irritation.
After handling logs, wash your hands gently
with soap and water.
Proper Log Placement
The positioning of the logs is critical to the safe
and clean operation of this heater. Sooting and
other problems may result if the logs are not
properly and firmly positioned in the appliance.
WARNING
Failure to position the parts in
accordance with this diagram
or failure to use only parts
specifically approved with this
appliance may result in property
damage or personal injury.
Log placement is critical to proper burner
performance. Logs must be correctly
positioned. The photos in this section show
the proper pinned position for logs and rocks
on this set. Owners need to be shown proper
log and rock placement and instructed not to
move the logs and rocks.
Logs and rocks must fit firmly onto the locating
pins when positioned as shown in the photos.
Malformed logs, rocks, or logs with sloppy pin
holes must be replaced.
Proper Placement of Crushed Glass
Media
This fireplace is designed to use one layer
deep of crushed glass media on the burner.
The maximum amount of crushed glass media
on the burner screen should not exceed 2-1/2
lbs. An additional 5 lbs. of crushed glass media
maybe spread out over the burner cover and
light glass panels.
It is recommended that prior to placing the
rocks and logs, add the single layer of crushed
glass on the burner screen after only. Then
the remainder of crushed glass media be
added after the log and rock set has been
properly installed.
