Page 55
Installation Instructions and Owner’s Manual - L48
ENGLISH
Caution: make sure wiring is not pinched
under mounting brackets.
13. Install the four halogen bulbs into the light
bracket sockets. It is recommended that
the bulbs be installed using extra care so
you do not touch the bulbs with oils from
fingers.
Figure 109
14. Re-install the burner cover assembly.
Place the burner cover over the burner
screen and burner. Place the ends of the
burner cover into the mating slots located
in the firebox side supports. Be sure to
position the burner screen so the pilot
cutout is centered on the pilot area. The
burner cover must hold the burner screen
flat against the top of the burner.
15. Re-install the rear liner panel. Place the
bottom tabs into the slots provided in the
rear support bracket, then install the (2)
screws removed in step 6.
16. Re-install the side liner panels. Align the
rear tabs with the slots provided in the
rear liner panel and install the (2) screws
removed in step 5.
17. Install the two accent glass panels onto
the framework over the lights.
Figure 110
18. Replace the Front Access Cover. See
.
19. The following figure shows the burner
cover, accent glass panels, and front
access cover installed.
Figure 111
20. To complete, refer to the section
for the proper
amount and placement of crushed glass
media on the burner screen area.
Note:
Do not apply more than one layer of
crushed glass over the burner porting areas.
21. Install glass door and barrier screen
assemblies.
22. To operate the lights, refer to section
«Multifunction Remote Operating
Instructions»
, page 38. The remote
does not have to be reprogrammed to
operate the light kit.
23. Installation is complete.
