Page 65
Installation Instructions and Owner’s Manual - L48
ENGLISH
GLASS PLACEMENT
Preparation of fireplace
NOTE :
The optional variable halogen lighting is
available. If used, follow instructions in section
«Variable Halogen lighting Kit Installation»
CAUTION
Turn off all power to the fireplace
prior to changing bulbs or
servicing the controls.
If a liner kit has not been installed, STOP
and install one before proceeding with media
placement.
1. Remove the light cover and verify that the
variable halogen lighting bulbs are installed
in the light bracket. These are located in
the reflective light bracket at the front of
the firebox. Use gloves or a soft cloth to
verify the light bulbs are plugged correctly.
Do not handle halogen bulbs with your
bare hands. Oils from your skin will cause
the bulb to burn out prematurely.
2. Install the two accent glass panels into the
metal retainer bracket located above the
lights. The two glass panels will be placed
so they meet together at the center of the
bracket.
ACCENT LIGHT COVER
DO NOT COVER WITH
CRUSHED GLASS MEDIA
ACCENT LIGHT GLASS PANELS (DVLL60)
ACCENT LIGHT COVER (DVLL48)
CRUSHED GLASS MEDIA ALLOWED
BURNER COVER
CRUSHED GLASS
MEDIA ALLOWED
CAUTION:
PLACE CRUSHED
GLASS MEDIA IN THE RECESSED
AREA AROUND THE PILOT, PILOT
SENSOR, OR IGNITOR PROBE
DO NOT
Figure 112
4. Replace the light cover over the lights.
5. If applicable, install logs and rock kit.
6. Add the decorative crushed glass media
of your choice at this time. Crushed glass
may cover the complete burner cover,
accent glass panels, and burner screen.
Place crushed glass media over the burner
screen in a single layer. Use just enough
crushed glass media to mask the burner screen
(approximately 1 sq. ft.). Additional crushed
glass may be placed over the burner cover and
variable halogen lighting glass panels.
Glass Quantity:
Use up to (5 sq. ft. of 1/4-
inch) crushed glass.
NOTICE:
• 1/4-inch crushed glass media is required on
the burner screen and accent glass panels.
• 1/4-inch crushed glass media is optional on
the burner cover or light cover (if the variable
halogen lighting is not installed.)
