Page 25
Installation Instructions and Owner’s Manual - L48
ENGLISH
The red and black battery extension harness
is connected to the red and black mating
connector pre-installed on the control module.
The mating connector can be located inside
the fireplace near the gas valve.
Locate and install the 5/8in diameter plastic
snap-in grommet over the low-voltage battery
and interface extension harnesses at the right
side of the fireplace. Snap the grommet into
the hole in the side of the fireplace just under
the access panel opening.
HAND BENT
FLANGE
WIRE
GROMMET
USER INTERFACE HARNESS
& BATTERY EXTENSION
HARNESS
CONNECT TO THE USER INTERFACE/BATTERY
HOLDER. MUST BE INSTALLED IN A WALL
JUNCTION BOX (ORANGE LOW VOLTAGE OR
BLUE BOX RECOMMENDED)
NOTE: OUTER ACCESS DOOR REMOVED. REPLACE AFTER ALL
WIRE AND GAS CONNECTIONS HAVE BEEN MADE
Figure 32
Run the extension wiring to the user interface
wall box and connect the white connector
to the remote receiver battery box. Install
the battery box into the wall outlet box, then
install the white remote cover supplied with the
provided screws.
