USER'S GUIDE____________________________________________________________________
134 _________________________________________________________________ M210704EN-F
Operation of the Indication LEDs
Relay is activated: LED is lit.
Relay is not activated: LED is not lit.
Setting the Relay Outputs
NOTE
When you have only one relay module installed, its relays are called
“relay 1” and “relay 2”.
When you have two relay modules, the relays of the module connected
to slot
MODULE 1
are called “relay 1” and “relay 2” and relays
connected to slot
MODULE 2
are called “relay 3” and “relay 4”.
0706-013
Figure 71
Relay Availability
Number refers to Figure 71 above:
1
=
Lists enabled relays. Activation state shown in black. Disabled
relays are not shown.
Use the display/keypad to set the relay outputs.
1.
Press any of the arrow buttons to open the
Main Menu
.
2. Select
Interfaces
, confirm by pressing the
►
arrow button.
3. Select
Relay outputs
, confirm by pressing the
►
arrow button.
4. Select
Relay 1/2/3/4
, confirm by pressing the
►
arrow button.
5. Select
the
Quantity
, confirm by pressing
Change
. Select the
Quantity by using the arrow buttons. Confirm your selection by
pressing
Select
. (Press
Fault Status
when the relay follows the
transmitter error.) Press
Change
to to set the value.
6. Select
Act. above / Act
. below. Press
SET
to confirm your
selection. If asked, select
MODIFY
if you want to set the setpoint
by using the arrow buttons. Select
REMOVE
if you want to
remove the setpoint.
