Configuring Video Behavior
S
YSTEM PAGE
, G
ENERAL TAB
Get the best video performance by adjusting for your environment. These settings are available in both
Low Latency mode and High Quality mode. They revert to their factory default values when you change
modes, so you will need to configure them again afterward.
Point Light Compensation
– Reduces the intensity of small, extremely bright areas (point light sources)
that would otherwise swamp the camera with light and make it difficult to see details in areas with less
intense lighting.
Anti-Flicker Filter
– Improves video quality if using 50 Hz mains power; no significant effect for systems
using 60 Hz power. This setting is on by default.
Image Flip
– If mounting the camera upside-down, set Image Flip ON. This orients the video image
correctly and sets the camera to respond appropriately to tilt commands from the remote, web interface,
and connected control devices.
18
Complete Manual for the IntelliSHOT-M Auto-Tracking Camera
