Installation
12
Connecting the filter inlet line to the domestic water supply
The connector and non-return valve are included in
the scope of delivery. Use the connector supplied.
Do not use an existing one. Screw the connector
onto a suitable ¾” thread on the water outlet in the
domestic water connection. Use the spanner to
tighten it. Insert the water line fully into the non-
return valve and then secure it with the clip.
1
Water valve
2
Spanner
3
Clip
4
Connector
5
Non-return valve
6
Filter inlet line
Once you have installed the filter, open the filter
water valve and allow the filter to be flushed
through for around 5 minutes before use.
The water will be a dark colour to start with.
This is normal.
The water lines must be connected to potable
water only. To work properly, the ice dispenser
requires a water pressure level between
207 kPa and 689 kPa (between 2.07 bar and
6.89 bar).
1
Potable water
2
Direction of water flow
Connecting the filter outlet line to the appliance
Connect the filter outlet line to the appliance inlet line using a two-way connector.
The water lines must be fully inserted into the centre of the connector to prevent any water
from leaking.
Secure each of the water lines using a clip. Check that
the clips are holding the water line securely in place. Open
the water valve to flush through the lines and check the
area around the water connections for leaks. If there are
any leaky points, check whether the lines are fully inserted
into the connector. If not, reinstall the lines and make sure
that they are completely tight and firmly attached.
1
Clips
2
Water line
3
Connector
