US drives PHOENIX EX, Instruction Manual, Page: 134 / 172

4-80 DRIVE PROGRAMMING
M13P08 COST PER KWH
Enter electricity cost for use by M13P05.
R-W Range: 00.00 to 100.00
Currency
Default: 0
M13B09 RESET POWER MTR
Set at 1 to reset M13P03 and M13P04.
R-W Range: 0 or 1
Default: 0
M13P10 STARTTIME TIMER1
Enter the running time the drive must operate before
timer1 counts down to zero.
R-W Range: 0 to 10000 h
Default: 0
M13B11 TIMER1 DONE
M13B11 is automatically set at 1 when M13P06 = 0. Set
M13B11 at 0 to reset countdown timer1. This causes
M13P06 to be loaded with the value of M13P10.
R-W Range: 0 or 1
Default: 0
M13P12 STARTTIME TIMER2
Enter the running time the drive must operate before
timer2 counts down to zero.
R-W Range: 0 to 10000 h
Default: 0
M13B13 TIMER2 DONE
M13B13 is automatically set at 1 when M13P07 = 0. Set
M13B13 at 0 to reset countdown timer2. This causes
M13P07 to be loaded with the value of M13P12.
R-W Range: 0 or 1
Default: 0
M13P14 GEN AMPLITUDE
Use this parameter to set the amplitude of the square
wave signal produced by the generator in percent.
R-W Range: 0 to 200.0%
Default: 0
M13P15 GEN OFFSET
Use this parameter to set the offset of the square wave
signal produced by the generator in percent.
R-W Range: -200.0 to +200.0%
Default: 0
M13P16 GEN PULSEWIDTH 1
Use this parameter to set the pulse width of the square
wave high-signal produced by the generator in msec.
R-W Range: 0.1 to 3276 sec
Default: 1
M13P17 GEN PULSEWIDTH 2
Use this parameter to set the pulse width of the square
wave low-signal produced by the generator in msec.
R-W Range: 0.1 to 3276 sec
Default: 1
M13P18 GEN OUTPUT
This parameter monitors the generator output.
R-O Range: MXXPXX
Default:
M13P19 GEN DESTINATION
Enter the parameter number to use as the destination for
the generator output signal.
Factory defaulted to an unused parameter.
Note: The scaling to the destination parameter is such
that when M13P18 (GEN OUTPUT) = 100.0 %, the
destination parameter will be set to its maximum value.
R-W Range: MXXPXX
Default: M00P00 (00.00)
M14P01 PID OUTPUT
The inputs to the
PID
controller are automatically scaled to
the range ±100.0%. The
PID
controller output is also
within this range.
Although it would appear that the variables have only a
10-bit resolution, internal calculations are made at a
higher resolution for greater accuracy. The displayed
values are scaled versions of the internal variables.
The output after the scale factor M14P15 is automatically
scaled to match the range of the destination parameter.
Gain parameters are actual units, as follows:
PID
output = Pe + le/s + Des
R-O Range: ±100.0 %
Default: