US drives PHOENIX EX, Instruction Manual, Page: 110 / 172

4-56 DRIVE PROGRAMMING
bit selector 2.
Factory defaulted to an unused parameter M00P00 which
is equivalent to setting the source to 1.
M09B15 BIT SEL2 SR1 INV
Set at 1 to invert the logic state of source 1 for bit selector
2.
R-W Range: 0 or 1
Default: 0
M09P16 BIT SEL2 SOURCE2
Enter the bit parameter number to be used as source 2 for
bit selector 2.
Factory defaulted to an unused parameter M00P00 which
is equivalent to setting the source to 1.
R-W Range: MXXBXX
Default: M00B00 (00.00)
M09B17 BIT SEL2 SR2 INV
Set at 1 to invert the logic state of source 2 for bit selector
2.
R-W Range: 0 or 1
Default: 0
M09B18 BIT SEL2 OUT INV
Set at 1 to invert the logic state of bit selector 2 output.
R-W Range: 0 or 1
Default: 0
M09P19 BIT SEL 2 DELAY
Enter a value for the required delay for selector 1 output
to become active (logic 1).
If the parameter value is positive, the delay is an “ON
Delay” as shown below.
If the parameter value is negative, the delay is an “OFF
Delay” as shown below.
R-W Range: 0 to ±3276.0 Sec
Default: 0
M09P20 DIGITAL OUT3 SRC
Enter the bit parameter number to be used as source for
digital output 3.
The default setting indicates when drive is at below
minimum frequency.
* Digital outputs 3 to 7 are optional.
R-W Range: MXXBXX
Default: M10B04 (10.04)
M09B21 DIGITAL OUT3 INV
Set at 1 to invert the logic state of digital output 3.
R-W Range: 0 or 1
Default: 0
M09P22 DIGITAL OUT4 SRC
Enter the bit parameter number to be used as source for
digital output 4.
The default setting indicates when the drive is At speed.
* Digital outputs 3 to 7 are optional.
R-W Range: MXXBXX
Default: M10B05 (10.05)
M09B23 DIGITAL OUT4 INV
Set at 1 to invert the logic state of digital output 4.
* Digital outputs 3 to 7 are optional.
R-W Range: 0 or 1
Default: 0
M09P24 DIGITAL OUT5 SRC
Enter the bit parameter number to be used as source for
digital output 5.
The default setting indicates when the drive is in Current
limit.
* Digital outputs 3 to 7 are optional.
R-W Range: MXXBXX
Default: M10B08 (10.08)
M09B25 DIGITAL OUT5 INV
Set at 1 to invert the logic state of digital output 5.
* Digital outputs 3 to 7 are optional.
R-W Range: 0 or 1
Default: 0
ON DELAY OFF DELAY