Accessory Terminals
Normally Closed connections must be made for proper gate opener
function.
The full accessory board is only found on the master control board.
J1—Terminal Board for Master card
Terminals
1 -
“Open/Close Function” This is a normally open terminal where by any device (i.e.
push button, keypad, receiver) which, by closing a contact, provides an opening
and/or closing pulse for
both
gate leaves (if there is only one leaf, it will control
the one leaf).
2 -
“Single Leaf Open/Close Function” This is a normally open terminal where by
any de-vice (i.e. push button, keypad, receiver) which, by closing a contact,
provides an opening and/or closing pulse for
only the gate leaf controlled by the
master control board
(if there is only one leaf, it will control the one leaf).
3 -
“Stop Command” This is a normally closed terminal where by any device (i.e.
push button) which, by opening a contact, halts gate movement.
IMPORTANT:
If
a connection is not made from this terminal to one of the - (negative) terminals
(i.e. 12, 13, 14, 15) gate motion will not commence.
4 -
“Opening Safety Device” This is a normally closed terminal where by any device
(i.e. photocells, sensitive edge, magnetic loops) which, if there is an obstacle in
the area they protect during opening, reverses gate direction to closing.
If the opening safety devices are tripped when the gate is closed, they prevent
the leaf movement.
IMPORTANT:
If a connection is not made from this terminal to one of the -
(negative) terminals (i.e. 12, 13, 14, 15) gate opening will not commence.
Summary of Contents for Sentry Swing
Page 49: ......