© UPLIFT Desk
• 800-349-3839 • 512-614-3152 • [email protected] • upliftdesk.com
6
Pictured here: Short Rail
(33.5” - 48.8” width adjustment between posts)
All rails come pre-assembled
Consisting of:
Cover
Rail housing
Rail extensions
(qty 2)
Also available: Long Rail
(51.5” - 73.8” width adjustment between posts)
Step 1
The Covers are not attached with screws during ship-
ment. Remove the Covers from each of the Rail as-
semblies and set them aside for later.
Remove the hardware and other components from
inside the Rail assemblies and set them aside for later
also.
Step 2
Turn each Rail assembly over and loosen the two
screws in each of the Rail extension washers using the
3mm Allen wrench. Do not remove the screws com-
pletely.
This will allow the Rail extensions to slide in and out of
the Rail housing.
Step 3
Move one of the Rail assemblies to the first two Posts
in your configuration. Slide the Rail extensions in or
out as needed so that they can be hung on the Posts.
Note:
Be sure that the upper and lower tabs on each
Rail extension are hooked over each Post top and
opening as shown.
Attach each Rail extension to each Post with an M5x12
Machine screw and tighten using the 3mm Allen
wrench.
M5x12 Screw
(qty 2)
Extension washer
(qty 2)
Parts needed for this part of the assembly
Assembly - Linear Configurations
