© UPLIFT Desk
• 800-349-3839 • 512-614-3152 • [email protected] • upliftdesk.com
10
Step 3
Each 120-Degree post is used with three Square posts
in 3-Pack and Dog Bone Shape configurations. Once
the posts for a 3-Pack configuration are assembled,
position them as shown to the left approximately
where they will be located once the Power and Data
Rail assembly is complete.
Power infeeds can be introduced through the 120-De-
gree post or any of the Square posts. Locate the pow-
er infeed post close to the power outlet (for plug-in
power infeeds) or the junction box (for hardwire pow
-
er infeeds) with the Power infeed hole facing the pow-
er source.
If you are assembling a Dog Bone Shape configura
-
tion, you will need two sets of 120-Degree and Square
posts. Note, in a Dog Bone configuration using UP
-
LIFT V2 Desks, two of the Square posts will need to
have Dual row center feet (see circled). If the desks
being used are not UPLIFT V2 Desks, we recommend
using Dual row end feet like the other posts.
Position the posts as shown to the left and approxi
-
mately where they will be located once the Power and
Data Rail assembly is complete.
After the posts for either configuration are assembled
and located where they need to be, move on to at-
taching your rails.
Dog Bone Shape Configuration
3-Pack Configuration
