© UPLIFT Desk
• 800-349-3839 • 512-614-3152 • [email protected] • upliftdesk.com
18
Step 2
Install the Data cable hangers into the holes located
in the Rail housing near the top and above the Pow-
er block. These will keep the data cables suspended
above the Power block and out of the way.
Step 3
Pull your cables out through the data window in the
side of the Power & Data Rail from the inside.
Connect a cable to one of the jacks following the in-
structions provided with the jack.
Step 4
Pull the finished cable & jack through one of the square
holes in the Data plate, from the back side.
Snap the jack into the one of the Data plate adapters
you selected in Step 1.
Step 5
Next, snap the Data plate adapter into the notches
of the square hole in the Data plate in the orientation
shown.
Step 6
Repeat Steps 3 through 5 with the second cable.
With both cable assemblies snapped into the Data
plate, fit the assembly into the data window in the side
of the Power & Data Rail.
Step 7
If you are not installing data in a particular data open-
ing, insert one of the included Blank plates.
