28
2.
Detection area(s) can be irregular on the grid.
3.
Set detection sensitivity for the camera to decide whether to report a motion detection alarm (alarm
visible on compatible NVR).
4.
Set alarm parameters.
Suppress Alarm(s): After an alarm is triggered, the same alarm will not be reported within the set time.
Clear Alarm(s): After an alarm is triggered,
a.
If the same alarm is not triggered within the set time, the alarm will be cleared and the same alarm
can be reported again.
b.
If the same alarm is triggered within the set time, the alarm will not be cleared until the suppress
alarm time expires. Then the same alarm can be reported again.
5.
Set actions to be triggered by motion detection alarm and the plan. For the detailed steps, see the
descriptions of alarm-triggered actions in
Configuring Motion Detection Alarm
6.
Click
Save
.
Configuring Tampering Alarm
Configure tampering alarm so that the camera reports a tampering alarm when the lens is blocked for a
certain length of time.
NOTE!
This function is not supported by some models. Please see the actual model for details.
The alarm triggered actions may vary with models. Please see the actual Web interface for details.
1.
Click
Setup
>
Events
>
Common Alarm
>
Tampering Alarm
.
