universalblue UBE2406-21, User Manual

Page: 77 / 82

77

The wall and induced heating zone above the table surface shall
withstand heat.

To avoid any damage, the sandwich layer and adhesive must be
resistant to heat.
CONNECTING THE HOB TO THE MAINS POWER SUPPLY
This hob must be connected to the mains power supply only
by a suitably qualified person.
Before connecting the hob to the mains power supply, check that:

The domestic wiring system is suitable for the power drawn by the
hob.

The voltage corresponds to the value given in the rating plate

The power supply cable sections can withstand the load specified
on the rating plate.
To connect the hob to the mains power supply, do not use adapters,
reducers, or branching devices, as they can cause overheating and
fire.
The power supply cable must not touch any hot parts and must be
positioned so that its temperature will not exceed 75˚C at any point.
Check with an electrician whether the domestic wiring
system is suitable without alterations. Any alterations must
only be made by a qualified electrician.
The power supply should be connected in compliance with the
relevant standard, or a single-pole circuit breaker. The method of
connection is shown below.