10
CHAPTER 3 BASIC INSTALLATION
A.
INSTALLATION STEPS
1. Connect the network cable to the Ethernet port at the rear panel of MX3600. Connect the other end to your
hub or switch.
2. Connect the power adapter to a power outlet, and plug the power cord into MX3600’s power input at the rear
panel.
3. Locate the power button at the rear panel of MX3600. Press it once to power on the NAS.
4. MX3600 will start a bootup process, and the system power LED will blink continuously. Boot up time is
approximately 1-3 minutes.
5. When the system power LED stops blinking and remains on, boot up process is complete.
B.
USB DEVICES – HOW TO DISCONNECT SAFELY
There are 2 ways of removing a USB device.
Method 1:
Press the USB eject button at the rear panel. Upon pressing the USB Eject button, you will hear the 1st beep sound.
After a few seconds you will a 2nd beep sound indicating that the USB device is allowed to be disconnected
Method 2:
You can also use the Windows utility installed from the Setup CD. After installing the utility from the CDROM, a
Flash Map icon will be displayed on the system tray.
Summary of Contents for MyXerver MX3600
Page 28: ...28 E SYSTEM SCREEN...
