GO1 User Manual
Copyright © 2021 Unitree Robotics. All Rights Reserved
6
Unpacking
Place the box on the flat ground according to the placement requirements (Face up), then open the
upper box and lift the whole robot out, as shown in the figure above. Remove the robot and remote
control, charger, etc. from the box, place the robot on the flat ground, untie the velcro strap of the robot's
leg, and then prepare for the boot.
Before Packing
First rotate the legs of the robot to the position shown in Figure [4] above(the rear leg is folded up: rotate
the rear leg hip motor so that the rear thigh is placed in the position shown in the above figure [4] above,
and the lower leg is closed. Place it in the position shown in Figure [4] above, and tie the left rear leg
and the right rear leg together with a Velcro strap, as shown in Figure [3] above. The front leg is folded
up: similar to the hind leg, as shown above Figure [3], [4] above placed and bundled).
If not using the robot for a long time, take out the battery pack and put it into battery box.
、
[1]
[2]
[3]
[4]
[8]
[5]
[6]
[7]
[1]Reserved space [2] Battery charging dock [3] Battery charger [4] Joystick [5] Tape [6]
Emergency stop button and type-C charger [7] Reserved space [8] Foot accessories