United Technologies Interlogix Advisor Advanced ATS1000A-SM, Manager Manual

Page: 84 / 100

76 Advisor Advanced Manager Manual
Appendix A. SMS control
This section specifies the SMS commands available in the systems equipped
with ATS7310 GSM communication modules. You can send commands to the
alarm system via SMS messages. These commands are listed in “SMS
command list
” on page 77.
See Advisor Advanced SMS Control Reference Guide for more information.
SMS control requirements
In order to use SMS control functions, you must follow these rules:
• Have a valid phone number defined in user options.
This setting is available both locally and remotely. See the Register and
Unregister command, as well as the Phone command description.
• Belong to the user group with the SMS control allowance.
• Have SMS control enabled. See the enable and Disable command
description for more details.
Command syntax
The following syntax is used for all commands:
[<PIN>] <command> [<parameters>] [, <command>
[<parameters>] ]
The following principles apply:
• Commands are case-insensitive.
• Any number of consecutive blank characters (spaces, tabs, CRs, etc.) are
interpreted as a single space.
• You can have up to 10 commands in one SMS message. Commands must be
separated with a comma.
• In most cases <list> is a space-separated list, or “all”. If <list> is “all”, or is
omitted, this is equivalent to a list of all objects for which the user has rights
for the selected action.
• If the parameter is a phone number, it should be given in the fully expanded
form, with country cod
e preceded by “+”. For example: +48555223322.
User authentication
The user is authenticated by the phone number sending the SMS message.
Only registered phone numbers are allowed to send SMS commands.
The PIN field is required, if:
• The “User PIN req.” option is set to Yes