Installation, Operation and Maintenance Manual
VariCool EZ-Fit
38
Subject to change without notice.
Screw Lugs & Terminals OK? Yes ___________ No ___________
Describe any loose connections and action(s) taken:
_________________________________________________________________________________________________
Power Supply Correct Voltage and Phase? Yes ___________ No ___________
If not in agreement with unit data tag contact the Distributor
_________________________________________________________________________________________________
Is the Circuit Protection the correct type and does it meet
the unit data tag requirements? Yes ___________ No ___________
If not correct describe what action(s) have been taken to correct:
_________________________________________________________________________________________________
Unit controller wiring verified? Yes ___________ No ___________
“C” Terminal hooked up if necessary? Yes ___________ No ___________
_________________________________________________________________________________________________
Unit leak check OK? Yes ___________ No ___________
If leak was located describe where and how repaired:
_________________________________________________________________________________________________
Condensate trapped & run to a suitable disposal point? Yes ___________ No ___________
_________________________________________________________________________________________________
Is the condensate trap primed? Yes ___________ No ___________
_________________________________________________________________________________________________
Air Filters are in place, clean & usable? Yes ___________ No ___________
_________________________________________________________________________________________________
Three Phase Measured Voltage L1-L2 ____________ L2-L3 ____________ L1-L3 _________
_________________________________________________________________________________________________
Evaporator Blower Motor Rotation OK? Yes ___________ No ___________
If three phase power and rotation is not correct describe action(s) taken to correct:
_________________________________________________________________________________________________
Supply Air External Static Pressure (ESP): In WG _____________
_________________________________________________________________________________________________
Verify that incoming fluid pressure does not exceed Yes ___________ No ___________
rating for the fluid control valves
_________________________________________________________________________________________________
Are unit piping and heat exchangers subject to freezing conditions? Yes ___________ No ___________
Water-Cooled Unit
Start-Up Procedures
Please complete the form and include
contact, start-up date and all requested
information
Job Name:
_________________________________
Date:
____________
Address:
____________________________________________________
City:
___________________________
State:
________
ZIP
____________
Unit Model No�:
______________________________________________
Unit Serial No�:
_______________________________________________
If yes, is corrective action being taken?
...............................................................
Yes ___________ No ___________
Please Describe:
Summary of Contents for VariCool EZ-Fit Series
Page 2: ......
