Unipulse F701+, Operation Manual

Page: 41 / 149

34
4 Performing Final Discharge Control
34
Pe
rfo
rm
in
g F
in
al D
isc
ha
rg
e
Chapter
4
4-8. Sequence control settings
Set various parameters to perform a series of operations from weighing start to weighing complete.
Normal sequence control
This is a control procedure to begin weighing by weighing start signals and to end weighing by
outputting complete signals.
Sequence control with adjust feeding
This is a control procedure to perform adjust feeding only for the period set in the adjust time when
weighing result is under.
4-8-1. Number of times for judging
This function is used to select over, under, or go
for judging when complete signal is output after
weighing has been completed.
00 : No judgment (Judgment of over, go, or under is not made)
01: Judgment is made every time.
02: Judgment is made once every two weighings.
03: Judgment is made once every three weighings.
99: Judgment is made once every 99 weighings.
4-8-2. Number of times for AZ
This function is used to select whether or not to
set the weighing value to zero when starting
weighing. This sets the weighing value to zero
by performing digital zero if the weighing value
is gross weight and by performing tare subtraction if the value is net weight.
00 : No auto-zero (Auto-zero is not performed)
01 : Auto-zero is performed every time.
02 : Auto-zero is performed once every two weighings.
03 : Auto-zero is performed once every three weighings.
99 : Auto-zero is performed once every 99 weighings.
[Number of times for judging] (Setting mode 1-6)
(Input range: 00 to 99)
Auto free fall compensation function uses over/under judging signals to save
compensation samples.
If number of times for judging is set to 00 (no judging), the F701+ cannot save
samples for auto free fall compensation and compensation function will not operate.
Set the number of times for judging to a number which is01 or more when using
auto free fall compensation function.
Attention
[Number of times for AZ] (Setting mode 1-5)
(Input range: 00 to 99)
- Auto-zero is performed with the following timing.
- Right after receiving ON edge of start.
-
Seq. error 3
is displayed when zero alarm is activated because auto-zero has
been performed.
- Operations of TARE from front panel keys and external I/O connector as well as
operations of digital zero are enabled even if no auto-zero (00) is set at this point.
Attention