61
7
OPTION (Setting Code 38)
61
OP
TION
Chapter
7
Note 1) Valid only in simple comparison mode.
Operation will result on OR condition with the hold function by external control input.
Note 2) Operation will result on OR condition with the sequence stop function by external control
input.
Note 3) Valid only in setting code 23; feed/discharge control mode is set at 3 (Communication).
Note 4) Valid only in setting code 25; auto free fall compensation is set at 2 (Communication).
Note 5) Valid only when setting code 48; calibration value LOCK ("
Release (Setting code 48)" on page 20) is OFF.
Be careful not to execute by mistake after calibration.
About RY (PLC
→
F160) signals
Signal
Meaning
Request
Reads or writes set values or performs operational commands at ON
edge.
R/W
Turns ON to read set values, and OFF to write set values or perform
operational commands.
Tare Subtraction
Does tare subtraction at the edge input.
Tare Reset
Cancels tare subtraction at the edge input.
Digital Zero
Zeros the gross weight at the edge input.
Digital Zero Reset
Cancels digital zero at the edge input.
Hold
Holds the weight value at ON, and cancels holding at OFF.
Note 1)
Sequence Start
Starts measurement in sequence mode at ON edge.
Sequence Stop
Stops the sequence at ON, and cancels the sequence stop at OFF.
Note 2)
Sequence Error Reset
Resets the sequence error at the edge input.
Zero Calibration
Starts zero calibration at ON edge.
Note 5)
Actual Load Calibration
Starts span calibration at ON edge.
Note 5)
Indicated Value
Net weight/ Gross weight
Selection
Switches the indicated value to be output to RWr0000-0001.
Indicates the gross weight at ON, and the net weight at OFF.
Feed/Discharge Selection
Can switch feed and discharge by setting this bit: discharge control at
ON, and feed control at OFF.
Note 3)
Auto Free Fall Compensation
Selection
Validates the auto free fall compensation function at ON,
and invalidates it at OFF.
Note 4)
CPS Write Inhibition Selection
Inhibits writing of the CPS set value from the CC-Link at ON,
and cancels it at OFF.
