52
7
OPTION (Setting Code 38)
52
OP
TION
Chapter
7
■
Signal Timing
- STAB
For example, if the output signal selection is set to "1: Stable,"
(B12)
This signal turns on at the same time as BCD data when stability is detected by
Motion Detect (MD).
("5-6.Motion Detect (Setting Code 31,32,37)" on page 25)
* Not only "Stable" but also any other output signal can be assigned.
- OVER
The ON condition differs according to the output data.
(B11)
Gross weight: OFL3, Net weight: OFL1 (Refer to "9-2Error List" on page 85),
Tare weight: Tare weight > 99999
- STROBE
Strobe pulses are outputted in synchronization with BCD data (duty50%).
(B13)
Read data using the rising edges of the pulses. The BCD data update rate setting
can be changed.
Example) Negative logic
CAUTION
- Do not apply external voltage to the signal input circuit.
- The external element is required to withstand Ic=10mA.
- Leakage from the external element is required to be 30
μ
A or below.
BCD data
STAB
OVER
0
1
0
1
BCD data
OVER
Storobe range
STROBE
0
1
