Page 35
X100 SERIES
INSTALLATION & OPERATING MANUAL
Manual No. x100-5a
x100-man-Rev5a-0214.indd
12.6 Comms
Clicking on the
Comms
button loads to Controller Network Settings page. This page
is used to setup the Ethernet and E-Mail communications settings.
Figure 10 - Controller Network Settings (typical)
12.6.1 Ethernet Settings
12.6.1.1 IP Address
This setting defines the IP Address for the controller.
The default factory setting of 192.168.0.200 is a designated ‘private’ IP
Address commonly used in IP based local area networks behind proxies,
NAT routers or network bridges.
To enter a new IP address use the up/down arrows to dial in the required
numbers or type them directly into the boxes as required. It is important to
press the ENTER key on completion.
12.6.1.2 Subnet Mask
This setting defines the Subnet Mask associated with the above IP Address.
The default factory setting is 255.255.255.0.
