![Unimig RazorWeld MS500 Operating Manual Download Page 10](http://html.mh-extra.com/html/unimig/razorweld-ms500/razorweld-ms500_operating-manual_842857010.webp)
10
Read instructions
• Use only genuine replacement parts
• Perform engine and compressor (if applicable) maintenance and service according to this manual and
the engine or air compressors (if applicable) manual.
H.F RADIATION CAN CAUSE INTERFERENCE
• High-frequency (H.F ) can interfere with radio navigation, safety services , computers and
communication equipment.
• Have only qualified personal familiar with electronic equipment to perform this installation.
• The user is responsible for having qualified electrician. Properly correct any interference problem
resulting from the installation.
• If notified by the FCC about interference, stop using the equipment at once.
• Have the installation regularly checked and maintained.
• Keep high-frequency source doors and panels tightly shut. Keep spark gap at correct setting, and use grounding
and shielding to minimize the possibility of interference
Arc welding can cause injury
• Electromagnetic energy can interfere with sensitive electronic equipment. Such as microprocessors,
computers, and computer-driven equipment such as robots.
• be sure all equipment in the welding area is electromagnetically compatible.
• to reduce possible interference, keep weld cables as short as possible, close together, and down low,
such as on the floor, Locate welding equipment 100 meters from any sensitive electronic equipment.
• Be sure this welding machine is installed and grounded according to this manual. If interference still occurs, the
user must take extra measures such as moving the welding machine, using shielded cables, using Line filters, or
shielding the work area.
To reduce magnetic fields in the work-pieces, use the following procedures:
1. Keep cables close together by twisting or taping them.
2. Arrange cables to one side and away from the operator.
3. Do not coil or drape cables around your body.
4. Keep welding power source and cables as far away from operator as practical.
5. Connect work clamp to work-piece as close to the weld as possible
Summary of Contents for RazorWeld MS500
