Uniks C6, Manual

Page: 10 / 28

10
12. Trigger
Press the trigger and the clamp opens: release the trigger and the
clamp automatically closes.
13. Clamp meter light
•
Press and hold the " INRUSH " button for more than 2 seconds to turn
the light on or off.
•
The light turns off automatically about 1 minute after it is turned on.
3. Instructions
WARNING
Do not measure any voltage higher than 600V DC or 600V
AC RMS to avoid electric shock and/or damage to the
instrument. Do not apply voltage exceeding 600V DC or 600V
AC RMS between the common terminal and the ground to
prevent electric shock and/or damage to the instrument
.
3.1 AC and DC voltage measurement
Insert the red probe into the " INPUT " jack, and the black probe into
the " COM " jack. Switch the function range switch to " " position, tap
the " SEL " button to switch between AC voltage, DC voltage and frequency
measurement modes, and connect the probes to the measured signal.
3.2 AC voltage and frequency measurement
•
When measuring AC voltage, tap the " SEL " button to switch the
display of the voltage value and frequency of the measured voltage;