Manual – Neon 2000 Family NRT & NRM
Unidata Manual - Neon 2000 Family Remote Terminals and Modules Issue 4.0.docx
Page 28
10.0
2011, 2013, 2014, 2016 SIM CARD INSTALLATION
The following section describes the procedure for installing a SIM into an NRT/NRM. This
section only needs to be performed if the SIM within the NRT/NRM needs replacing, or if it
is known that the NRT/NRM does not contain a SIM.
Remove the lid screws (either two or four screws depending on model).
WARNING
: Care should be taken when handling lithium batteries as misuse may cause
damage to the NRT/NRM or, the battery cells may explode.
Ensure that the battery terminals are NOT shorted and that there are no loose wires in the
vicinity the battery.
Remove the battery from its holder.
Locate the SIM socket.
Slide the SIM cover gently with a fingernail or matchstick until it clicks. The SIM cover can
now be lifted gently and hinged open.
Insert the SIM with the gold contacts away from you and the cut corner at the top left as
shown below
SIM card inserted.
Close the SIM cover and slide it into place until it clicks.
