Programming Manual UTG1000X Series
Instruments.uni-trend.com
49
/
51
The following command can generate the sawtooth wave as shown above.
:CHANnel1:MODe CONTinue
:CHANnel1:BASE:WAVe RAMP
:CHANnel1:BASE:FREQuency 30000
:CHANnel1:BASE:HIGH 2
:CHANnel1:BASE:LOW 0
:CHANnel1:BASE:PHAse 90
:CHANnel1:RAMP:SYMMetry 20
:CHANnel1:OUTPut ON
Configuring Impulse Wave
This section is to introduce how to configure the impulse wave.
Explanation
An impulse wave has an amplitude, an offset, and a phase relative to a synchronous pulse. It also
adds slope of edge and duty cycle (or pulse width). It can use high voltage value and low voltage
value to set its amplitude and deviation.
Example
The following wave can set by SCPI command, high voltage value and low voltage value can
replace :CHANnel1:BASE:AMPLitude and :CHANnel1:BASE:OFFSet
