CONNECTING THE SOLAR PANELS TOGETHER.
-
13
7. Connecting the Solar Panels Together.
- Cont.
INSTALLATION MANUAL eco-SPARK™ SOLAR POOL HEATER
Notice that the latch and the latch lock are connected. Gently disconnect the two
parts from the small plastic bit holding them together. Discard the small piece and
keep both the latch and latch lock near by.
Use channel lock pliers to tighten the clip grip by squeezing it with reasonable force
until it seats flush or even slightly farther so it cannot slide out of its position.
Lock the two halves of the clamp together using the latch (2-1410-018). Do this by
sliding the wide end of the cone shaped latch over the thin end of the PPC assembly.
Use channel lock pliers to tighten the latch grip by squeezing it with moderate force
until you hear a ‘click’ sound and it seats flush so it cannot slide out of its position.
Move your finger over the wide end of the latch to make sure it is in fact flat. This will
confirm that it is positioned securely.
Take the latch lock and tilt it so the lock’s gripping teeth are positioned
inside the groove of the latch. Gently press downwards into position until
you hear a ‘click’ sound or the latch lock is flat against the latch.
If you wish to dismantle the PPC Set, strongly pull the latch lock upwards while your
thumb is holding the flat part of the latch or use a flat-head screwdriver. Gently
insert the flat-head screwdriver under the lock and gradually pull upwards until it is
released from place. If the latch lock is in good conditions it can be used again. The
gasket (O-ring) will be better replaced
7.
8.
9.
10.
11.
©
2015 UMA Solar
