MOUNTING THE SOLAR PANELS USING eco-SPARK MOUNTS
-
18
NOTE:
As the installing contractor, it is your job to evaluate any site specific conditions that might create
unwanted roof wear. As an example, if you are installing the system on an inexpensive or soft asphalt shingle
roof, you’ll want to put some 4” by 4” pads underneath each panel clamp along the bottom headers to prevent
roof wear. Some installers make these pads from aluminum roof flashing or old mat systems, and attach them
to the roof with roof sealant or an adhesive.
NOTE:
Install lower header based on temperature at the time of installation.
NOTE:
Typical residential mounting plan shown. For additional mounting options for commercial installations
please refer to addendum provided by manufacturer’s engineering department.
eco-SPARK Top Mounting Pad
(Placed at panel rail)
eco-SPARK Top Mounting Pad
(Placed at panel rail)
PPC
PPC
PPC
PPC
Pipe Strap
(To support plumbing)
Pipe Strap
(To support plumbimg)
8. Mounting the Solar Panels
Using eco-SPARK Mounts.
- Cont.
Fig. 8.6
INSTALLATION MANUAL eco-SPARK™ SOLAR POOL HEATER
©
2015 UMA Solar
