um Unverferth 2750, Operator'S Manual And Parts Catalog, Page: 54 / 112

3-8
Assembly
2. Units with standard electric shutoff: route
the wiring harness around the Seed Run-
ner box, along the hydraulic hoses inside
spiral wrap and follow up the conveyor
to the hydraulic drive motor. Unplug the
exisiting wire harness connector from the
hydraulic control valve and plug the mating
end of wiring harness (27938) into the wir-
ing harness removed. Attach the remaining
connector on wiring harness (27938) to the
electric valve on the motor.
Units with radio remote control: route the
wiring harness (27938) to the hydraulic
control valve. Locate the connector with
the purple wire. Disconnect the connector
with the purple wire from the solenoid and
connect it to the mating connector on wiring
harness. Attach the remaining connector of
wiring harness (27938) into the solenoid
where the purple wire was removed.
Route wiring harness along hydraulic
hoses inside the spiral wrap
Route wiring
harness along
the conveyor
to the hydraulic
motor
Unplug exisiting
wire harness from
valve on motor
Plug wiring harness (27938) to wiring
harness removed from hydraulic valve
on motor. Secure under cable tie.
Connect wiring
harness (27938)
to valve on motor
Revised 082610-1