Ultrasonix Sonix MDP, Service Manual

Page: 134 / 148

Chapter 11: Maintenance 00.053.205, Revision A SonixMDP/SP/OP Service Manual
11-4
11.2.8 Transducer Holders and Cable Hooks
Apply a small amount of one of the following recommended cleaning solutions to a soft, non-abrasive cloth and
wipe off the transducer holders and cable hooks:
• water
• mild detergent (PH level at or near 7) and water solution.
11.2.9 Footswitch (Dual and Triple)
Apply a small amount of one of the following recommended cleaning solutions to a soft, non-abrasive cloth and
wipe off the footswitch:
• water
• 70% isopropyl alcohol.
11.2.10 Peripheral Tray and Basket
Apply a small amount of one of the following recommended cleaning solutions to a soft, non-abrasive cloth and
wipe off the peripheral tray and basket:
• water
• mild detergent (PH level at or near 7) and water solution.
Cautions:
Power off and unplug the system prior to cleaning.
For best results, Ultrasonix recommends removing the transducer holders and cable hooks before cleaning (
7.8.1 ).
This will allow the operator to clean all the various curves and folds in a more effective manner.
DO NOT apply cleaning solutions directly to the transducer holders and cable hooks.
Warning: Disconnect the footswitch prior to cleaning.
Caution: DO NOT apply cleaning solutions directly to the footswitch.
Note: Over time, silk-screened graphics may be damaged by the solvent effect of the isopropyl alcohol.
Cautions:
Power off and unplug the system prior to cleaning.
For best results, Ultrasonix recommends removing the peripheral tray basket before cleaning (
7.8.2 ). This will
allow the operator to clean all the various curves and folds in a more effective manner.
DO NOT apply cleaning solutions directly to the peripheral tray basket.