Ultrasonix Sonix MDP, Service Manual

Page: 119 / 148

SonixMDP/SP/OP Service Manual 00.053.205, Revision A Chapter 8: DICOM
8-23
8.2.3.5 DICOM Worklist Settings
To Configure DICOM Worklist Settings:
1.
Press the console button.
2.
Select Administrator > DICOM > Worklist… .
3.
Using the DICOM Print data collected in 8.2.1 complete the following Application Entity (AE) fields: ( SCP )
AE Title , IP Address and Port .
4.
Enter a Name under Devices and select Add .
5.
Select OK to accept the changes or Cancel to exit without saving.
To Test DICOM Worklist Devices:
1. Press the console button.
2.
Select Administrator > DICOM > Worklist… .
3.
Under Devices , highlight the relevant Name .
4.
Select Test to activate the C-Echo command for the highlighted SCP .
5. If successful, the Test result will produce a message similar to this example.
6.
Select OK to continue.
To Delete DICOM Print Devices:
1.
Press the console button.
2.
Select Administrator > DICOM > Storage… .
3.
Under Devices , highlight the relevant Name .
4. Select Delete to remove the device from the list.
5.
Repeat step 3 and step 4 as many times as necessary.
6.
Select OK to accept the changes or Cancel to exit without saving.
Note: As far as DICOM is concerned, the device Name is meaningless. Because multiple devices can be
added, the sole purpose of the Name is to provide clarity for the Operator .
Note: The network must be connected with the relevant server running.