Assembly
18
Fig 26
Grub screw
Hex key
Straight edge
Step 3 Insert the two countersink Hex screws down into
the countersink holes in the table inset to lock the insert in
position, see fig 27.
Fig 27
Countersink Hex screw
Fig 28-29
Step 2 Insert three (1/4”) square nuts (h) into the machined
slot to each fixing bracket (L), see fig 30. Locate the two
fence fixing brackets (K), M6 Hex screws (e) and flat washers
(j), line up the machined slots in the bracket (K) with the
square nuts (h) and secure both brackets with the M6 Hex
screws (e), see fig 31. DO NOT OVERTIGHTEN
UJK Fence Assembly
Step 1 Locate the fence fixing brackets (L) and the six
Hex screws flat and spring washers (f). Line up one of the
brackets with the pre-drilled holes beneath the edge of
the table and secure in place with four Hex screws (f),
see figs 28-29. Repeat for opposite side.
Pre-drilled holes
L
f
Fig 30-31
h
K
e
j
Step 3 Loosen the two locking knobs beneath the fixing
brackets (K), slide the two scales into the top of fixing
brackets recess and lightly tighten the knobs, see fig 32.
