Assembly
20
Step 8 Loosen the two locking knobs beneath the fixing
brackets (K), slide the two scales until it reads (ZERO) to the
front face of the fence assembly, lightly tighten the locking
knobs, see figs 38-39-40.
Scale
Scale set to Zero
Fig 38-39-40
K
Locking knob
Step 9 Locate the extraction moulding (I), loosen the two
locking knobs (b) either side of the extraction surround on
the fence (H), slide the extraction moulding (I) over the ‘T’
bolts (d) and retighten the locking knobs (b), see fig 41
WARNING! DO NOT OVERTIGHTEN THE
LOCKING KNOBS AS THE EXTRACTION
MOULDING IS ONLY PLASTIC!
Fig 41-42-43
I
b
Step 10 Locate two ‘T’ bolts (d), fence spacers (c) and flat
washers (i). Slide the ‘T’ bolts into the fence (H) ‘T’ slot and
position the bolts roughly the width of the extraction
moulding (I) and place a fence spacer (c) over the ‘T’ bolt
thread, see figs 42-43.
d
H
