Assembly
15
Step 6 Turn the stand over, locate the tool bracket (2) and
M6 fixing 6-7-8. Insert the coach bolt (6) through the centre
hole in the tool bracket (2) and into the pre-drilled hole in
the centre panel (F), angle the bracket and secure using
fixing (7-8), (See figs 9-10-11)
Fig 06-07
Fig 08
Step 5 Locate the four rubber feet (3), (M6x20mm) Phillips
screws (4), flat washers (7) and M6 nuts (8), see fig 6.
Turn the stand over, place a rubber foot on top of the leg
support bracket (A)and line up the pre-drilled holes. Place
a flat washer (7) over the Phillips screw (4) and insert the
screw into the foot’s recess, secure in place with the nut
(8), see fig 6-7. Repeate the process for the remaining feet,
see fig 8.
3
4
7
8
Fig 09-10-11
7
6
2
8
F
Step 7 Turn the frame over, locate the mitre fence bracket
holder and two Phillips screws/washers (1). Lineup the
holes in the bracket with threaded holes in the centre panel
Fig 12
(F) and secure in place with the Phillips screw. (See fig 12).
Step 8 Locate the two (M4) Phillips screws and nuts (5-9),
place a nut onto the Phillips screws an screw them into
the two threaded hole in the centre panel (F), (See fig 13).
1
Phillips screws
Continues Over...
