Assembly
14
UJK Router Table Stand Assembly
Step 1 Locate the bag containing the coach bolts
(M6x12mm) (6), M6 flat washers and nuts (7-8), leg support
brackets (A) and side upper/lower panels (D-E). Offer up
the pre-drilled holes in the leg supports with the holes in
the upper/lower panels as shown in fig 1 and secure using
the M6 nuts bolts washers. DO NOT OVERTIGHTEN. Repeat
for the remaining legs (A) and panels (D-E).
Fig 01
6 7 8
E
A
D
Step 2 Locate the side centre panel (F) and one of the
stand sides, offer up the holes in the centre panel with
holes in the centre of the leg supports (A) and secure with
M6 fixings (6-7-8), see fig 2
NOTE LEAVE FIXING HOLE (A)
CLEAR TO MOUNT THE TOOL
BRACKET (2) LATER IN THE
ASSEMBLY.
Fig 02
F
A
a
Step 3 Find the rear extractor panel (G) and front lower
panel (C). Lightly tighten both panels to the stand side as
show in fig 3, using the M6 fixings. Attach the remaining
stand side to the other end, see fig 4.
Step 4 Locate the front and back upper panels (B) and
attach it to the frame work as shown in fig 5, then go
round and tighten all the fixing.
Fig 03
C
G
Fig 04
Stand side panels
Fig 05
B
