IB-COM
38
List of Special options
Special Option No. 25
In factory setting the IB-COM only sends a data format if a decoder with the appropriate
format is addressed and is still in the refresh cycle. Alternatively the IB-COM can be setup
so that this data format is constantly being output even if no address with this data format
was called before.
For example the malfunctioning of some Motorola decoders can be prevented this way
where they automatically switch into the analogue mode the instant they stop receiving the
Motorola signal.
The input value is calculated by the following table. The values of the desired options are
added.
Option Value
DCC signal only if required
permanent DCC signal
0
1
Motorola signal only if required
permanent Motorola signal
0
2
Example
If the Motorola signal is to be sent permanently and the DCC signal only if required the
input is calculated as follows:
DCC signal only if required
value = 0
Permanent Motorola signal
value = 2
The calculated sum (here 2) is entered as value for this special option.
Factory setting is 0.
Special Option No. 97
Determines the state of the IB-COM after it is switched on.
0 = [stop] key is activated. The driving power is switched off.
1 = [go] key is activated. The driving power is switched on.
Factory setting is 1.
Special Option No. 907
This sets the digital signal which the IB-COM transmits, if no locomotive is in a refresh
cycle, e.g. after switching on the layout before the first locomotive is called.
1 = Motorola
4 = DCC (factory setting)
Summary of Contents for IB-COM
Page 1: ...The Digital Center for PC Manual...
Page 37: ...IB COM 37 Appendix...
