UGO BASILE - I
TALY
Page 23
Series 58000 Instruction Manual (Rev.1)
9.3
How to Set a Customized Experimental Configuration
From the main menu, press the
F2
(
FNC
) key, followed by the
F1
(
OUT
) key. Depress
the key
F2
(
FTR
) again; the display shows:-
This function enables the operator to personalize basic in-
put data, by adding:
sequence number (see paragraph 9.3.1)
gender of the animal (see paragraph 9.3.2)
All the available selections for each additional information
are displayed in a loop, on the right side of the middle level
of the graphic display.
Scroll though them by the
F1
(
↑
) or
F2
(
↓
) keys, select the parameter and confirm the
selection by pressing the
F3
(
OK
) key. To avoid one or more features, press the
F4
(
NUL
) key.
By pressing and releasing the arrow keys, the numerical value will increase or decrease
of one step. By keeping them pressed longer, the selection can be made at higher speed.
The selected features will be kept in the instrument’s memory even when it is turned off.
To erase one or more parameters previously set, simply enter this software level,
highlight the concerned feature and depress the F4 (NUL) key.
After entering the last parameter (M or F), the software automatically returns to the main
menu.
9.3.1
Sequence Number
The first additional parameter to be defined is the sequence number (or trial number). This sec-
tion is highlighted as soon as the
F2
(FTR)
key is depressed. Use the
F1
(
↑
)
or
F2
(
↓
)
keys to
set the desired sequence number
from 01 to 99
and confirm it by depressing the
F3 (OK)
key.
The sequence number will automatically increase by one, upon any subsequent measurement.
It advances once a trial has been acquired and re-
corded, indicating the fresh sequence number ready for
the next measurement.
If a sequence number is not necessary, depress the
F4
(NUL)
key:
