![background image](http://html.mh-extra.com/html/udp-technology/ipn1202hd/ipn1202hd_installation-manual_834308007.webp)
IPN Series
IPN1202HD-5241 Installation Guide
01A.03
UDP Technology Ltd.
7
①
Power Adaptor Connect
The camera requires DC 12V for power supply. Refer to the section “
4.3. Connecting Cables
”
for more specific information
②
PAL/NTSC button
Press the PAL/NTSC button to set video output as PAL or NTSC. The default is no video output.
Each time pressing the button cycles through PAL, NTSC, and no video output mode:
No video
output -> PAL->NTSC
③
11 pin terminal block for D/I, D/O, audio, and serial communication
Refer to the section “
4.3. Connecting Cables
”
for more specific information.
④
Analog Video Out Connector
Use BNC cable (not supplied) to connect between the camera and monitor to verify image
focuses at the installation site. Users must cycle through button (no video output -> PAL ->
NTSC) to select the video output. Once the PAL/NTSC button is pressed, the video displays for
3 minutes before returns back to ‘no video output’ status.
⑤
Reset Button
Use the reset button to restart or reset the camera back to factory default settings. Refer to
the section “
5.3. Reset”
for more specific information.
⑥
RS-485 Termination Switch (120ohm)
Select ON or OFF for RS-485 termination register. The default is off.
⑦
Network Port
Use the RJ45 LAN connector for connecting the camera to network or supplying PoE power.
⑧
USB 2.0 Port
Plug an USB flash drive or wireless LAN device.
⑨
SD Card Slot
Supports memory cards up to 32GB.
⑩
Auto Iris Lens Connector
The 4-pin connector for an auto iris camera lens.
⑪
Light Sensor
The light sensor is used to detect the level of ambient light detect intensity of light. The sensor
should not be blocked by cable or any other objects.