![background image](http://html.mh-extra.com/html/udp-technology/ipn1202hd/ipn1202hd_installation-manual_834308010.webp)
IPN Series
IPN1202HD-5241 Installation Guide
01A.03
UDP Technology Ltd.
10
Power Connection
The camera can be powered from either 12VDC or PoE. If the camera is powered via PoE, refer
to
Appendix (B). Power over Ethernet
for more details. To operate your camera using 12VDC,
make sure the polarity is correct before connecting the power cable. Incorrect connection may
cause damages to the IP device.
Analog Video Out Connection
Use a 75 ohm video coaxial cable to connect to a monitor’s analog video output and check the
camera’s connection and its image focus at the installation site. Be sure to press the output
configuration button (PAL/NTSC button), located on the left side of the reset button to see the
video. The factory default is ‘no video output’; Press once to set the video to PAL, and press
again to set the video to NTSC. Pressing the button again will go back to ‘no video output’
mode, disabling the viewing through the analog video connection.
Note
i
The video output configuration must be set before you connect the power
cable. When changes get made while power cable is connected, users must
restart the device to reflect the change. Once the PAL/NTSC button is pressed,
the video display lasts for 3 minutes before it goes back to ‘no video output’
mode.
Note
i
Users cannot adjust the video brightness while connected through the analog
video output. The brightness can be controlled only from a Web browser.
Audio connection
The camera provides a mono audio input and output. Due to low audio output power, an
amplified speaker is recommended for enhanced sound. (Reframe from connecting a
headphone or earphone directly to the camera.)
RED
+
-
+
-
BLACK