AeroCut Velocity OPERATION MANUAL
34
・
5.5 Fine adjustments on processing positions
5.5.1 In cases cutting positions don’t match to image positions.
①
Make sure the original sheets are printed correctly and consistently.
②
Ensure that image positions correspond to inputted data.
⇒
If it does not, amend input values so that they correspond to image positions.
③
If the cutting positions shifts along feeding direction, input a value on micro adjustment
according to below picture.
In case cutting positions shifts toward the lead edge.
If the image position moves as the left drawing,
increase the width of gutter.
Measure the difference of images between first
card and the last card.
Revised values can be calculated by dividing
the difference by number of gutters.
EX
：
In case the gap is 0.138” and there are 6
gutters between cards, 0.138”
÷
6= 0.023”
should be inputted.
In case cutting positions shift towards the trailing edge.
If the image position moves as the left drawing,
decrease the width of gutter.
Measure the difference of image between first
card and the last card.
Revised values can be calculated by dividing the
difference by number of gutters.
EX
：
In case the gap is -0.138” and there are 6
gutters between cards, -0.138
÷
6= -0.023”
should be inputted.
MANU SET screen
+0.023”
MANU SET screen
-0.023”
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
