AeroCut Velocity OPERATION MANUAL
41
20.
Crease back margin error
Correct the crease back margin to
exceed the value specified below.
21.
Perforation location warning
Correct the perforation location to fit in
the value range below. The maximum
value is subject to change depending on
the entered paper size.
22.
Cut piece number error
Correct the number of cut pieces to be
in the value range below.
The maximum number of pieces is
subject to change depending on the
operation
.
23.
Top margin error
Correct the top margin to fit in the value
range below.
24.
Bottom margin error
Correct the bottom margin to fit in the
value range below.
25.
FLEX MODE input error 1
This error results when the three input
values shown in the following figure are
“0” or lower at FLEX MODE time.
26.
FLEX MODE input error 2
Slitter units positioning error.
Slitter position is out of valid range.
Check paper size and input data.
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
