UCHIDA AeroCut nano+, Service Manual

Page: 54 / 61

AeroCut nano+ SERVICE MANUAL
54
7. The guillotine doesn’t cut paper properly.
7-a. In case there is a mark on the lead edge of the card.
・
It may occur when the paper is too thick.
・
It may occur when the gap between the cards are too short.
・
There may be a gutter remaining on top of the guillotine blade.
7-b. In case there is a mark on the tail edge of the card.
・
It may occur when the paper is too thick.
・
There may be a gutter remaining on top of the guillotine blade.
7-c. In case there is no mark on the card.
・
The micro switch of the guillotine unit may be defective. It happens
sometimes.
If it always occurs, make sure that the input values of MANU SET are right.
Feed
Feed
Feed