PenSigner
V2.0 Program
PenSigner
Program allows you to sign your name or to draw a simple picture and
insert it into a document. As soon as
PenSigner
is initiated, you can start drawing
anywhere on the screen after you choose Pen Button
or Brush Button
. By
default,
PenSigner
awaits until you press OK Button
before it sends out your
drawing. You may also set it up so that
PenSigner
automatically sends out the
drawing after you pause for a certain period of time. The latter mode is convenient
when you wish to many simple drawings to a number of places in the document.
PenSigner
inserts your drawing into Target Window, the window (other than
PenSigner
) that was last active before you press OK Button. Normally, your drawing
appears immediately in the Target Window after you press OK Button. However, if
you changed the Target Window to one that does not accept graphs, the drawing may
appear to be lost. In such case, you should immediately pick the correct window and
invoke Paste function to attempt inserting the drawing again. You must be careful not
to invoke the Edit /Copy function that changes the contents of system Clipboard.
Startup
You start the
PenSigner
Program by Selecting “Start” at the lower left corner of the
screen, and then selecting Programs, Tablet, and finally
PenSigner
. Naturally, you
may copy this Shortcut to other convenient places, such as on the Desktop. As soon
as
PenSigner
is started, you will see the Unexpanded Toolbar:
.
Figure 55 The
PenSigner
Unexpanded Toolbar
When you are ready to start drawing, tap on either Pen Button or Brush Button on the
Unexpanded Toolbar. This will display the following Expanded Toolbar, and you can
then start drawing anywhere on the screen. If the Toolbar is in the way, you can
move it anywhere else on the screen by pressing and holding at the rectangular title
area at the top.
