NINA-B50 series - Hardware integration manual
UBX-22021116 - R02
Regulatory compliance
Page 45 of 57
C1-Public
6.4.5.2
FCC Compliance
For an end product that uses the NINA-B50 modules, there must be a label containing, at least, the
information shown in
The label must be affixed on an exterior surface of the end product such that it will be visible upon
inspection in compliance with the modular approval guidelines developed by the FCC.
☞
In accordance with 47 CFR § 15.19, the end product shall bear the following statement in a
conspicuous location on the device:
"This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions;
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation."
The label must be affixed on an exterior surface of the end product such that it will be visible upon
inspection in compliance with the modular approval guidelines developed by the FCC.
When the device is so small or for such use that it is not practicable to place the statement above on
it, the information shall be placed in a prominent location in the instruction manual or pamphlet
supplied to the user or, alternatively, shall be placed on the container in which the device is marketed.
In case, where the final product will be installed in locations where the end-user is not able to see the
FCC ID and/or this statement, the FCC ID and the statement shall also be included in the end-product
manual.
6.4.6
End-product compliance
6.4.6.1
General requirements
•
Any changes to hardware, hosts or co-location configuration may require new radiated emission
and SAR evaluation and/or testing.
•
Only authorized antenna(s) may be used.
•
Any notification to the end user about how to install or remove the integrated radio module is NOT
allowed.
•
The approval of the modular transmitter in NINA-B50 series modules does not exempt the end
product from being evaluated against any applicable regulatory demands. The evaluation of the
end product shall be performed with the NINA-B50 series module installed and operating in a way
that reflects the intended use case of the end product. The upper frequency measurement range
for the end product evaluation is the 5th harmonic of 2.4 GHz as declared in 47 CFR Part 15.33
(b)(1).
•
The following requirements apply to all products that integrate a radio module:
o
Subpart B - UNINTENTIONAL RADIATORS
To verify that the composite device of host and module complies with the requirements of
FCC part 15B the integrator shall perform sufficient measurements using equipment
compliant with ANSI 63.4-2014.
o
Subpart C - INTENTIONAL RADIATORS
The integrator must carry out sufficient verification measurements, using compliant ANSI
63.10-2013 equipment, to validate that the fundamental and out-of-band emissions of the
transmitter part of the composite device comply with the requirements of FCC part 15C.
When the items listed above are fulfilled, the end product manufacturer can use the authorization
procedures as mentioned in Table 1 of 47 CFR Part 15.101, before marketing the end product.
