typical YSC-8331, User Manual

Page: 22 / 26

21
06 Bus over current Check the load.
08 Load is too heavy Check the load.
10 Position check error Check synchronizer, see 8.2.
11 Encoder error Check encoder, see 8.4.
13 Machine type error Check identifier, see 8.6.
14 Trimmer SOL. error Check SOL. whether direct short.
15 REV SOL. error Check SOL. whether direct short.
16 Wiper SOL. error Check SOL. whether direct short.
17 Foot lifter SOL. error Check SOL. whether direct short.
8. Signal Checking
Press wheel button during power on, it will display “TEST” and then enter
the mode of Measurement of Input Signal. Turning wheel button can change
the index of signal test.
8.1 Pedal
Display of the different pedal position as below:
Display code Descriptions
High speed The second segment forward, pull is 02~99.
Low speed The first segment forward, pull is 01.
Balance position Default.
Foot position The first segment backward.
Trimmer position The second segment of backward.
Error position Speed controller fault or disconnected.
8.2 Synchronizer
Turn the hand wheel by hand equably, display of up position.
8.3 Switch
Display code Descriptions
L:
The LED lightness, can be set by and .
R: The state of REV. switch.
C: The state of COR. switch.
S: The state of safety switch.