23
A:
Phase A current sample value.
B:
Phase B current sample value.
8.14 Degree
First to setup zero point, use
or
to change degree type, turn
hand wheel equably, display the current degree.
¾
Zero
Index
Turn hand wheel to top dead center, and then press wheel button
to set
zero degree point.
¾
Up
lever
Turn hand wheel to up lever, press wheel button
to save current degree
to up lever position. If display is equal to existent parameter, a twinkling “O”
will be displayed.
The setup of other degree parameters are same with above.
¾
Down
lever
¾
Trimmer
Start
¾
Trimmer
End
¾
Reverse
Start
¾
Reverse
End
¾
Clamp
Start
¾
Clamp
End
¾
Puller
start
¾
Puller
End
8.15 Date & Time
8.16 Fault review
The system can save the error code automatically when error occurred.
Checking the history error by operation as below:
If there has fault message, press wheel button to move curser under fault
index, turning wheel button to change index, total 10 fault message can be
stored; press
back to the index of signal test.
use
or
can display the fault information, as below:
